Removing The Camshaft Seal
NOTE:
Crankshaft and camshafts must not be turned more than is stated in the method description
If the shafts are turned in any other way the valves may be damaged.
Remove:
- the cable from the battery negative terminal.
First read Battery, disconnecting .
- the cross stay between the suspension turrets
- the air intake hose for the turbocharger (TC) from the air cleaner (ACL) cover. Put to one side
- the upper timing belt cover
- the cover over the ignition coils
- the upper engine stabilizer brace
- the camshaft position (CMP) sensor housing
- the trigger wheel
- the servo reservoir and the expansion tank. Lift up and place on top of the engine.WARNING:
Ensure that no power steering fluid is spilled. Extremely flammable.
- the auxiliaries belt
- the front timing belt cover.