LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2004 >> S80 Base, 2.5 59, FWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - Removal, Replacement And Installation >> Timing Gear (B5254T2; 2004) >> Camshaft Seal/Variable Valve Timing (VVT) Unit, Replacing >> Installation >> Replacing The Rear Camshaft Seal

Replacing The Rear Camshaft Seal

Fig 1: Identifying Special Tool Extractor 999 5919
GLL102728Courtesy of VOLVO CARS OF NORTH AMERICA.

Pull out the seal. Use puller 9995919 . Use emery cloth 951 1024 to clean the shaft journal and mating surface.

NOTE:

When cleaning work around the shaft journal, not in and out. It is essential that any residue from the emery cloth and any other contaminants are completely removed before the new sealing ring is installed.

Lubricate the surface of the seal that the camshaft rotates against. Install the camshaft seal. Use drift 9995450 .

NOTE:

The seal is normally pressed in so that it is level with the internal bevelled edge.

If the shaft journal is showing signs of wear, the seal can be pressed in 2 mm deeper by turning the drift socket.

scientia non olet · About LEMON Manuals