Installing Components

Fig 1: Installing Anti-Roll Bar Links

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install new nuts on the ball joints. Tighten to 80 Nm  .

Counterhold using a Torx wrench so that the ball joint boot is not damaged.

Install the anti-roll bar links. Use new nuts. Tighten to 50 Nm  .

Counterhold using a Torx wrench so that the boot is not damaged.

Install: 

• the screw and nuts for the steering gear. Use new nuts and new screws. Tighten to 50 Nm 
• the front engine pad. Tighten to 50 Nm 
• the torque rod. Tighten the screws through the oil pan. Tighten to 50 Nm  . Tighten the nuts in the sub-frame. Tighten to 65 Nm 
• the center screw for the drive shaft. Use a new screw. Counterhold using a screwdriver in the brake disc vents. Tighten to 50 Nm 
• the front air baffle
• the front wheel.