Installing Components On The Sub-Frame

Fig 1: Identifying Oil Pipe And Clamps For Steering Gear

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install: 

• the screw for the cable and air duct
• the oil pipe for the steering gear in the snap fasteners along the sub-frame
• the hose for the EVAP canister in the clip on the upperside of the sub-frame
• the engine block heater and the fuel line to the engine block heater if applicable
• the air duct in the clips
• the screw for the ground cable bracket
• the connectors for the heated oxygen sensors (HO2S) in the clips at the rear of the sub-frame.