Transferring Components

Fig 1: Identifying Sub-Frame Components

Courtesy of VOLVO CARS OF NORTH AMERICA.

Transfer 

• the control arms. Use new screws and new nut. Tighten the front screws. Tighten to 65 Nm  . Angle-tighten 90°  . Use bevel protractor 9512050 . Tighten the rear screw. Tighten to 105 Nm  . Angle-tighten 90° 
• the anti-roll bar. Tighten to 60 Nm 
• the right-hand engine mounting. Tighten the screws. Tighten to 65 Nm  . Angle-tighten 60° 
• the mounting for the heated oxygen sensor (HO2S) wiring
• the engine pad.

Install new pipe / hose holders.