Installing Right Engine Pad

Fig 1: Engine Mountings Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install 

• the new engine pad.
• new screws  for the mounting in the sub-frame (A) and engine (B). Do not tighten yet. 

Carefully lower the engine and remove mobile jack.

Tighten the screws to the sub-frame to 65 Nm (47.9 lb. ft)  and angle-tighten 60°  . Use bevel protractor 9512050 .

Tighten the screws to the engine to 35 Nm (25.8 lb. ft)  and angle-tighten 90°  .

• the crankshaft vibration damper. Tighten to 35 Nm (25.8 lb. ft)  . Angle-tighten 50°  .
• both the plastic nuts holding the cover in the right fender liner.
• right front wheel according to Installing wheels .