LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2004 >> S80 Base, 2.5 59, FWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - Removal, Replacement And Installation >> Engine Mounting (1999-2006) >> Bushing Sub-Frame, Replacing >> Installing The Wiring For The Heated Oxygen Sensor (HO2S)

Installing The Wiring For The Heated Oxygen Sensor (HO2S)

Fig 1: Heated Oxygen Sensor Bracket
GLL109024Courtesy of VOLVO CARS OF NORTH AMERICA.

Lift up the sub-frame slightly (approximately 50 mm from the car body).

Install the bracket for the heated oxygen sensor (HO2S) on the sub-frame.

Install the heated oxygen sensor (HO2S) wiring on the right hand side of the sub-frame (applies to 6- cylinder engines only  ).

scientia non olet · About LEMON Manuals