Removing/Installing The Rear Camshaft Seal: Finishing

Fig 1: Identifying Trigger Wheel, Camshaft Position (CMP) Sensor Housing, Air Cleaner (ACL) Cover, Intake Manifold Between Electronic Throttle Module (ETM) & Engine Stabilizer Brace

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install: 

• the trigger wheel. Tighten the screw
• the camshaft position (CMP) sensor housing. Tighten the screws
• the air cleaner (ACL) cover
• the intake manifold between the electronic throttle module (ETM) and air cleaner (ACL) cover
• the engine stabilizer brace. Tighten the screws
• the screw holding the engine stabilizer brace to the bracket on the engine. Tighten.

Test drive the engine.