LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2004 >> S80 Base, 2.5 59, FWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - Removal, Replacement And Installation >> Drive Train (B6284T; 1999) >> Replacing The Timing Belt >> Installing The Tensioner / Damping Unit

Installing The Tensioner / Damping Unit

Fig 1: Identifying Tensioner/Damping Unit
GLL108818Courtesy of VOLVO CARS OF NORTH AMERICA.

Check that there is no visible leakage.

Press the tensioner/damping unit together with tool 9995456 . Position the tensioner/damping unit in the tool and screw the tool center nut to the bottom. Wait until it is compressed and then install a lock pin in the piston.

NOTE:

The tensioner damping unit must  be replaced if there is leakage or there is no resistance when pushed in or if it cannot be pushed in.

Install the tensioner/damping unit. Tighten to 25 Nm  .

scientia non olet · About LEMON Manuals