Removing/Installing The Rear Camshaft Seal: Preparation

Fig 1: Engine And Stabilizer Brace

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove: 

• the screw holding the engine stabilizer brace to the bracket on the engine
• the screws holding the engine stabilizer brace to the suspension turrets
• the engine stabilizer brace
• the intake manifold between the electronic throttle module (ETM) and air cleaner (ACL) cover
• the air cleaner (ACL) cover. Place it to one side
• the camshaft position (CMP) sensor housing and the trigger wheel.