Installing The Cylinder Head / Gasket: Finishing

Fig 1: Clamp For Vacuum Pipe (Turbocharger (TC) 1)

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install: 

• the screws for the oil return line. Use new gaskets
• lower coolant pipe. Use new gaskets. Tighten to 26 Nm 
• the pipe screw for the pressure oil outlet on the engine. Use new gaskets. Tighten to 38 Nm 
• the clamps between the oil pressure pipe / coolant pipe and the intake pipe for the water pump
• the vacuum hose on the pressure regulator (turbocharger (TC) 1)
• the clamp for the vacuum pipe (turbocharger (TC) 1).

Fig 1: Intake And Charge Air Pipes, Turbocharger And Upper Heated Oxygen Sensors

Courtesy of VOLVO CARS OF NORTH AMERICA.

Tighten: 

• the three-way catalytic converters (TWC) in the turbocharger (TC). Use new nuts. Tighten to 24 Nm 
• the pipe screw for the oil pressure pipe. Tighten to 18 Nm 
• the upper heated oxygen sensors (HO2S). Lubricate the threads using copper paste 116 1408  . Tighten to 45 Nm  .

Install the heat deflector plates.

Install the upper coolant pipes. Use new gaskets. Tighten the pipe screw. Tighten to 26 Nm  .