Installing Components To Turbo 2

Fig 1: Installing Torque Rod Bracket, Upper Screw Securing Automatic Transmission Dipstick Pipe To Engine & Ground Leads

Courtesy of VOLVO CARS OF NORTH AMERICA.

Lower the car. 

Tighten the pipe screw of the oil pressure pipe to 18 Nm  .

Install 

• the charge air pipe. Position and tighten the clamp.
• the intake pipe. Position and tighten the clamp.
  NOTE:

  Remove the previously installed seals.

• the torque rod bracket.
• the upper screw securing the automatic transmission dipstick tube to the engine. Tighten the lower screw.
• the heat deflector plate above the turbocharger.
• the ground cable between the firewall and the torque rod bracket.
• the clamp between the coolant pump intake pipe and the turbocharger oil pressure pipe.