LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2004 >> S80 Base, 2.5 59, FWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - Removal, Replacement And Installation >> Cylinder Head (B6284T; 1999) >> Cylinder Head/Gasket, Replacing >> Removing The Cylinder Head Gasket >> Compressing The Tensioner / Damping Unit

Compressing The Tensioner / Damping Unit

Fig 1: View Of Compression Tool
GLL125943Courtesy of VOLVO CARS OF NORTH AMERICA.

Assemble tool 9995750 . Install the tool between the lever pulley and the lifting lug at the servo pump.

Slacken off the screw in the tool so that there is clearance of approximately 10 mm between the screw head and the tool.

Allow the tool spring to compress the tensioner / damping unit.

scientia non olet · About LEMON Manuals