Installing The Sealing Ring
CAUTION:
Only Volvo approved engine oil may be used. Grease must not be used at all. It attracts dirt and results in the build up of coke.
Lubricate the sealing ring mating surface against the cylinder block and the lips of the seal.
Thread the seal onto the bevelled part of the inner section of 9997174 with the felt side of the seal outward.
Screw the drift onto the crankshaft (2 screws) of the flywheel.
Pull in the seal with the outer part of the drift, 9997174 , using the screw in the center of the tool. The seal is in place when the outer drift bottoms against the inner drift. Remove tool 9997174 . Scrap the old flywheel screws.