Installing The Camshaft And Tappet
Install both the tappets for the inlet valves at cylinder 1.
Check the notes made earlier. Select new tappets if necessary.
NOTE:
Only install two tappets. The tappets should be placed by the same cylinder
Other tappets are available as replacement part / replacement part kits.
The valve clearance on a cold engine (approximately 20 °C) should be:
| Inlet valve:0.20 0.03 mm. |
| Exhaust valve:0.40 0.03 mm. |
NOTE:
The tolerances are less when setting When checking the valve clearance through the plug hole, the tolerances are larger.
Position the intake camshaft. Ensure that the lobes at cylinder 1 point upwards.
Apply a little oil to the cam lobe and the upper side of the tappet to facilitate later measurement.