Installing The Camshaft Covers

Fig 1: Installing Camshaft Covers

Courtesy of VOLVO CARS OF NORTH AMERICA.

Lubricate the camshaft lobes, the camshaft bearing surfaces and the valve lifters.

Install the camshaft cover.

Install press tool 9995454 (2x).

Tighten the camshaft cover screws alternately, keeping it parallel to the cylinder head with the press tools.

Install the intake manifold and lifting eyes, tighten screws from the middle and outwards.

Remove the press tool 999 5454

Install 

• the spark plugs. Tighten to 30 Nm 
• the variable valve timing (VVT) solenoid with a new gasket
• the plugs for the test holes. Tighten to 20 Nm 
• the ignition coils according to the earlier marking
• the ground terminals between the ignition coils
• the upper engine stabilizer brace
• the cable duct for the coolant temperature sensor.

Connect the connectors for the 

• the coolant temperature sensor
• Variable valve timing solenoid.