Installing The Camshaft And Valve Lifter
Install both the valve lifters for the inlet valves at cylinder 1.
Check the notes made earlier. Select new valve lifters if necessary.
NOTE:
Only install two valve lifters. The valve lifters should be placed at the same cylinder
Other valve lifters are available as replacement part / replacement part kits.
The valve clearance on a cold engine (approximately 20° C) should be:
| Inlet valve:0.20 0.03 mm. |
| Exhaust valve:0.40 0.03 mm. |
NOTE:
The tolerances are less at setting When checking the valve clearance through the plug hole the tolerances are larger.
Position the intake camshaft. Ensure that the lobes at cylinder 1 point upwards.
Apply a little oil to the cam lobe and the upper side of the valve lifter to facilitate later measurement.