Valve Clearance, Setting / Adjusting: Finishing

Install 

• front timing cover
• the auxiliaries belt
• the expansion tank
• the servo oil reservoir
• the bleed hose for the expansion tank.

  Close the clamp and check that the hoses lie correctly.

Connect the connectors for the 

• The ABS sensor by the right suspension turret
• the coolant level sensor in the expansion tank.

Install 

• the starter motor
• the air cleaner (ACL) intake pipe
• the trigger wheel.
  NOTE:

  Ensure that the trigger wheel is correctly positioned against the camshaft.

• the camshaft position (CMP) sensor housing
• the cover at the rear edge of the camshaft
• the screws holding both the ground strips from the firewall to the cylinder head
• the cover over the ignition coils
• the upper timing cover.

Install (B6284T) 

• the protective cover over the injector connectors
• plastic charge air / intake pipe over the engine. Tighten the clamps
• the crankcase ventilation hose to the PTC valve. Use a new clamp
• the connector for the PTC valve
• the cover over the PTC valve
• EVAP, "bypass"hoses and control hoses for boost pressure.

Install (B6294S) 

• the upper section of the intake manifold. Use a new gasket
• vacuum hoses to the intake manifold.

Install (common) 

• the engine stabilizer brace between the suspension turrets Clamp the servo hose to the right mounting for the engine stabilizer brace in the bodywork
• the plastic nuts for the cover in fender liner
• the right front wheel according to Installing wheels
• the cable to the battery negative terminal. See Battery, disconnecting .