Preparation (common)

Fig 1: View Of Ignition Coils & Connectors

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove 

• ground strip from the engine stabilizer brace
• the screw from the upper mounting for the transmission dipstick pipe
• engine stabilizer brace
• ignition coils, without  disconnecting connectors.
  NOTE:

  Mark up before removal.

• both ground terminals
• the connector for the variable valve timing solenoid
• the connector for the engine coolant temperature (ECT) sensor.

Put the wiring and ignition coils to one side.

• the right front wheel
• the plastic nuts on the cover on the fender liner.