Finishing Work (Common)

Fig 1: View Of Ignition Coils & Connectors

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install 

• plugs in inspection holes. Tighten to 20 Nm  .
  NOTE:

  Take care  when tightening the plugs for the inspection holes.

  Do not  exceed the torque listed or the threads in the cam cover may strip.

• the ignition coils according to the earlier markings
• both ground terminals
• the connector for the variable valve timing solenoid
• the connector for the engine coolant temperature (ECT) sensor
• engine stabilizer brace. Tighten to 50 Nm 
• ground strip to the engine stabilizer brace
• the screw for the upper mounting for the transmission dipstick pipe.

Remove tool 999 5755.