Finishing Work (B6294S)

Fig 1: View Of Ignition Coils & Connectors

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install 

• the trigger wheel. Tighten to 17 Nm  .
  NOTE:

  Ensure that the trigger wheel is correctly positioned against the camshaft.

• the camshaft position (CMP) sensor housing
• the clamps that hold the wiring to the rear of the cylinder head
• the cover over the ignition coils
• the upper timing cover
• the engine stabilizer brace. Tighten the screws at the suspension turret. Tighten to 50 Nm  . Tighten the screw on the engine stabilizer brace. Tighten to 80 Nm 
• the covers over the suspension turrets
• the plastic nuts for the cover in fender liner
• the right front wheel Installing wheels .