Finishing Work (B6284T)

Fig 1: Engine Compartment Components

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install 

• new cover at the rear edge of the intake camshaft
• the clamps that hold the wiring to the rear of the cylinder head
• the cover over the ignition coils
• the upper timing cover
• plastic charge air / intake pipe over the engine. Tighten the clamps
• the engine stabilizer brace. Tighten the screws on the suspension turret. Tighten to 50 Nm  . Tighten the screws on the engine stabilizer brace. Tighten to 80 Nm 
• the covers over the suspension turrets
• plastic nuts on the cover in the fender liner
• the right front wheel Installing wheels .