Install The Oil Pump

Fig 1: Identifying Oil Pump And Special Tool 999 5455

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install new oil pump 

• Install a new gasket
• Carefully insert the oil pump over the end of the crankshaft.
  NOTE:

  Make sure that the seal ring in the oil pump is not damaged during installation

• Install 4 new screws as guides
• Pull in the oil pump with drift 9995455 and the crankshaft center nut.
  NOTE:

  Make sure that the crankshaft does not rotate when pulling in the pump.

• Tighten the screws crosswise. Tighten to 10 Nm 
• Install the crankshaft timing gear pulley.

  Carefully tap alternately around the pulley until end position is reached.

  NOTE:

  The timing gear pulley only fits in one position on the crankshaft's splines.