Installing The Engine Cooling Fan (FC) And Fan Shroud

Fig 1: Cable Harness Secured Using Tie Straps

Courtesy of VOLVO CARS OF NORTH AMERICA.

Carefully lower the fan shroud and align with the holders. Route the cable harness behind the holder (3).

Tighten both the mounting screws

Press the hose down from the expansion tank into the holder on the fan shroud

Transfer the clips from two tie-straps to the tie straps that have two catches (1).

Secure the cable harness by the fan shroud using tie straps (1) and (2).

Install: 

• the canister purge (CP) valve
• the hose clamp and charge air pipe/hose on the right-hand side (turbo charged engines only)
• the intake manifold to the air cleaner (ACL) housing.

Connect the engine cooling fan (FC) connectors.

Fig 2: Fan Shroud Bracket

Courtesy of VOLVO CARS OF NORTH AMERICA.

Transfer the bracket (1) to the new fan shroud.

Install the connectors for the fan on the bracket using the holder from the service kit (2).