Installing the central electronic module (CEM)
CAUTION:
The pins are fragile. Check that the connectors go straight down into the control module.
Install:
- the control module on the bracket. Press the control module forward so that the catches enter the bracket
- the connectors
- the soundproofing panel on the driver's side
- the 2 screws on top of the control module
- the 2 connectors on top of the control module.
NOTE:
Make sure that the rubber seal is correctly positioned in the groove.
Install:
- the cover
- the wiper arm mechanism. See Wiper mechanism and wiper motor, windshield, replacing
- the battery negative cable. See Battery, disconnecting .