Removing the control module
The rear electronic module (REM) is a separate unit in the relay box in the cargo compartment.
- Remove the integrated relay/fusebox. See Removing the integrated relay/fusebox in the cargo compartment .
- Unscrew the screw holding the connector so that it is free of its threads. Check that the screw is free using your fingers
- Disconnect the connector. Use an open spanner and a support as shown.
NOTE:
Do not damage the pins.
- Remove all relays and shunts bridged to the control module.
Note the locations.
- Release the catch on the rear. Use a screwdriver
- Lift and pull out the control module.