Replacing the component

Replace relay for "Reversing lamp" (location 2/80) and check relay connection, in particular the relay control (2/80 2), for an open circuit as described in Open-circuit, permanent faults .

Additional information: 

• For -2003, see Signal specification
• For 2004, see Signal specification
• To access/replace the relay, see Integrated relay/fusebox cargo compartment/Rear electronic module (REM), replacing
• When relay is installed and not activated, relay control voltage should be 12 V.

Fig 1: Identifying Ohm Meter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Relays

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Continue 

  Refer to Verification