Replacing the component

Replace relay for "Reversing lamp" (location 2/80) and check relay connection, in particular the relay control (2/80 2), for a short circuit to voltage supply as described in Short-circuit to supply voltage. Permanent faults .

Additional information: 

• For -2003, see Signal specification
• For 2004, see Signal specification
• To access/replace the relay, see Integrated relay/fusebox cargo compartment/Rear electronic module (REM), replacing
• When relay is installed and activated, relay control voltage (2) should be 0 V.

Fig 1: Identifying Voltage Display

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Relays

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Continue 

  Refer to Verification