Checking the wiring

Check wiring between central electronic module (CEM) #9A and beam setting control module #2 (6/38) for LH and (6/39) for RH actuator, for short circuit to ground, as described in Short-circuit to ground, permanent faults .

Check wiring between central electronic module (CEM) #9A and beam setting control #2 (6/38) for LH and (6/39) for RH actuator for an open circuit, as described in Open-circuit, permanent faults .

Do the necessary corrective action.

Additional information: 

• For information on the central electronic module (CEM), see Central electronic module (CEM), replacing .

Fig 1: Identifying Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohm Meter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Ground Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Is there a fault? 

• YES 

  Refer to Verification 

• NO 

  Refer to Information