Checking the wiring

Check the relay coil driver circuit for an intermittent short-circuit to supply voltage by taking a voltmeter reading between terminal #2 and ground in the relay base for relay 2/118.

For further information about a short-circuit to supply voltage, see Short-circuit to supply voltage, intermittent faults .

HINT: The voltage between terminal #2 and ground should be approximately 0 volt. 

Other information 

• See Central electronic module (CEM), replacing

Fig 1: Identifying Voltage Display

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Relays

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Continue 

  Refer to Information