Checking start

Use the same key which previously could not start the engine. Carry out three more start attempts.

HINT: If the start attempts are carried out in quick succession, remove the key from the ignition switch for at least two seconds between each start attempt. Otherwise a new transponder check will not be carried out. (If the key is left in the ignition switch between each start attempt, a new transponder check will not occur until the ignition has been switched off for approximately 30 seconds.). 

One of the following may occur:

1. The engine starts every time

   Refer to Communication 

2. The engine starts at least once

   Refer to Damaged transponder 

3. The engine does not start.

   Refer to Incorrect key