Checking the power supply and ground for the engine control module (ECM)
Checking the power supply
- Check the fuse for the engine control module (ECM) in the fusebox in the engine compartment. If the fuse is blown, check the circuit after the fuse. Check for a short-circuit to ground
- Check the power supply to the engine control module (ECM). The voltage must be approximately battery voltage.
Checking the ground terminal
- Check the ground leads between the engine control module (ECM) and the ground terminal. Check for an open-circuit
- Check the ground terminal for the engine control module (ECM). Check for contact resistance and oxidation.
Remedy as necessary
Other information
- To connect the breakout box, see Connecting the breakout box
- For information about the location of ground terminal for B52X4 S/S2, see Location of components
. For information about the location of ground terminal for B52X4T see Location of components
. For information about the location of ground terminal for B6304S:
- For 6 cylinder naturally aspirated engines -2001, see Location of components
- For 6 cylinder naturally aspirated engines 2002, see Location of components, engine compartment
- For 6 cylinder naturally aspirated engines 2003-, see Location of components, engine compartment .
- For 6 cylinder turbocharged engines -2001, see Location of components
- For 6 cylinder turbocharged engines 2002, see Location of components, engine compartment
- For 6 cylinder turbocharged engines 2003-, see Location of components, engine compartment .
- For information about signals on 5-cylinder naturally aspirated engines, see Signal specification
- For information about signals on 5-cylinder turbocharged engines, see Signal specification
- For 6 cylinder engines -2001, see Signal specification
- For 6 cylinder engines 2002-, see Signal specification
- For 6 cylinder engines -2004, see Signal specification
- For 6 cylinder engines 2005-, see Signal specification .
Was a fault detected?
- YES
- NO
Refer to Checking communication with the engine control module (ECM)