Connecting the breakout box

CAUTION:

The voltage supply to the control module must be disconnected when disconnecting the breakout box. Failure to observe this procedure could seriously damage the control module.

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Disconnecting Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

For more help with connection see Measuring instruments .
Ignition off
Disconnect the transmission control module (TCM).
Connect adapter 9511504 to transmission control module (TCM) connector and connect breakout box 9511428 to the adapter.
NOTE:
Ensure that the adapter is the right way round - with the breakout box cable harness outwards towards the fender.

Fig 3: Breakout Box
Courtesy of VOLVO CARS OF NORTH AMERICA.

Continue
Refer to Checking ground terminals