Checking components and wiring

Check the signal cable to the relay for the electric engine block heater. Check between accessory control module terminal #B5 and the connector for the relay. Check for a short-circuit to ground.

Remedy as necessary.

Other information: 

• To connect the breakout box, see Connecting the breakout box. Accessory electronic module
• To access or replace the Accessory Electronic Module (AEM) and connector, see Replacing the accessory electronic module
• For information about signals, see Signal description. Accessory electronic module (AEM)
• To access and replace the relay for the electric engine block heater, see Replacing the relay for the electrical engine block heater
• To fault-trace wiring and terminals see Checking wiring and terminals

Fig 1: Accessory Electronic Module Ground Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohm Meter

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Continue 

  Refer to Verification