Installing The Center Tunnel Console
Position the center tunnel console.
NOTE:
Align the gas strut for the cover / arm rest.
Thread in the cable harness at the front edge.
NOTE:
Ensure that the cable harness is not positioned around the console.
Install the 8 screws.
Install:
- the connector
- the lighter socket
- the switch
- lamp, ashtray.
Thread the cable harness into the end panel at the front of the center console. Turn the center console locker into position.
Install:
- the connector at the front center console
- the end panel
- the 2 screws for the end panel
- the connector at the rear of the DVD player
- the connection at the joint on the antenna cable.
Align the center console locker with the front center console and the brackets at the seat belt mounting.
Install:
- the 2 screws
- the coolbox. See Replacing the cool box .
Do not forget the connectors for the seat cushions.
Connect the battery lead. See Battery, disconnecting .