Checking contact resistance and oxidation
Check 10 CD changer and head unit/audio control module connectors for contact resistance and oxidation according to Contact resistance and oxidation .
Check cable between the amplifier #D6 and head unit/audio control module #D6 for an open-circuit according to Open-circuit, permanent faults .
Remedy as necessary.
Other information:
- To access/replace the amplifier, see Power amplifier .
- To access the 10 CD changer, see Power amplifier .
- To access/replace head unit/audio control module:
- For -2004, see:Radio cassette player, replacing .
- For 2005-, see:Audio unit, replacing .
- To connect the breakout box, see Connecting the breakout box, Audio control module .
- For information about signals and connectors, see Signal specification, audio control module
If the 10 CD changer is now OK, the fault was due to a bad connection in the connectors.
Is the 10 CD changer OK?
- YES
OKAY: Troubleshooting has been completed.
- NO
Refer to Checking wiring and components