Remove the drive shaft from the transmission

Fig 1: Identifying Drive Shaft Removal From Transmission Using Jimmy Tool 999 5736

Courtesy of VOLVO CARS OF NORTH AMERICA.

Use jimmy tool 9995736 .

Position the two jimmy tools opposite each other.

Detach the drive shaft.

NOTE: Pull the constant velocity joint , not the drive shaft joints, when removing the drive shaft. There is no axial pinion.

NOTE: Take care not to damage the drive shaft when removing it from the transmission.

Install plug 9995730 on the transmission.

Fig 2: Identifying Rubber Seal & Constant Velocity Joint

Courtesy of VOLVO CARS OF NORTH AMERICA.

CAUTION: Later models have a rubber seal on the constant velocity joint. Do not damage the seal. It will be needed for installation.