Drive shaft right, replacing: Installation

Installing the drive shaft in the transmission 

Lubricate the drive shaft mating surface. Use wheel bearing grease P/N 116 1241-3 (80 g).

Install the drive shaft on the transmission and the mounting for the pilot bearing with the bearing cap and the 2 M8 screws. Tighten.

Install the drive shaft to the wheel hub. See Drive shaft, left, replacing .

Checking the transmission fluid level 

The following applies to cars with manual transmissions: 

To check the transmission fluid, see Drive shaft, left, replacing .

Installing other components 

Install: 

• the splash guard under the engine
• the wheel. See Installing wheels .

Checking the transmission fluid level 

Check the oil level.