Installing shock absorbers, lateral links and anti-roll bar links (both sides)
Press the control arm downwards when the shock absorber is being installed. Use a crow bar.
Install:
- the shock absorbers on the control arms. Do not tighten the screw
- the screw for the lateral link/wheel bearing housing. Do not tighten the screw
- the link to the anti-roll bar on both sides. Use a new nut. Tighten.
CAUTION:
For certain versions, remove the levers for the level sensor from the control arm(s).
NOTE:
The level sensor may be installed on both the right and left side.