Installing members and the exhaust system

Fig 1: Exhaust Pipe/Catalyst

Courtesy of VOLVO CARS OF NORTH AMERICA.

Tighten: 

• the 4 M8 screws for the support for the center bearing
• the 2 M8 screws for the propeller shaft center bearing.

Install: 

• the front member on the bodywork, the exhaust pipe and the three-way catalytic converter (TWC), 4x M8. Tighten
• the brake pipe in the mountings in the member
• the rear exhaust pipe assembly. Use a new gasket between the three-way catalytic converter (TWC) and the rear exhaust system.