Installing the propeller shaft, front

Fig 1: Identifying Tightening Propeller Shaft

Courtesy of VOLVO CARS OF NORTH AMERICA.

Check carefully that the mating surfaces on the propeller shaft and flange are clean.

NOTE: If the same propeller shaft is to be reinstalled. Install the propeller shaft according to markings, see Removing the front propeller shaft .

Tightening the propeller shaft CV joint

Use new screws.

First tighten the screws crosswise. Tighten to 8 Nm . Then tighten to 30 Nm .

Use counterhold 9995743 .