Assemble the ABS hydraulic modulator and the bracket

Fig 1: ABS Hydraulic Modulator Bracket

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: The ABS hydraulic modulator is filled with brake fluid. It is important that the plugs are not removed until the brake pipes are to be connected.

Install the new ABS hydraulic modulator

Install the new ABS hydraulic modulator on the bracket. Tighten the mounting screws. Tighten to 8 Nm .

Hold the vacuum hose to one side and carefully install the bracket in the car (the hose between the bracket and the side member).

Connect the pump motor connector to the control module. Tighten the mounting screws. Tighten to 8 Nm .