Faulty signal: Verification

HINT: After carrying out the repair, check that the fault has been remedied. 

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Connecting Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off
• Reinstall the components, reconnect the connectors etc.
• Ignition on
• Test drive the car. See Test Drive Form (DSTC (dynamic stability and traction control)/brake control module), description .

  Check the ABS warning lamp during the test drive.

  If the fault has been remedied the lamp will go out when the speed exceeds 20 km/h.

  If the warning lamp does not go out, return to the workshop and read off the diagnostic trouble codes (DTCs).

Does the ABS warning lamp go out and remain unlit? 

• YES 

  VERIFIED:  Troubleshooting has been completed.

• NO 

  Refer to Information