Checking the connectors and cables

Check the relevant wheel sensor and ABS control module connectors for contact resistance and oxidation according to Contact resistance and oxidation .

Check the connectors and wiring insulation for damage.

Check that the wheel sensor cables are not too close to sources of interference.

Remedy as necessary.

Other information 

• To connect the breakout box, see Connecting the ABS breakout box
• To disconnect the control module connector, see Control module (ABS), replacing
• To check and replace the wheel sensors, see Wheel sensors, rear, replacing
• For information about signals, see Signal specification, ABS control module .

Was a fault detected? 

• YES 

  Refer to Verification 

• NO 

  FAULT NOT FOUND:  Troubleshooting has been completed.