Checking components and wiring

Check that fuse 11C/35 or 11C/36 in the passenger compartment integrated relay / fusebox is intact.

Check the cable between control module terminal #4B and the power window motor #3. Check for a short-circuit to ground. Check for a short-circuit to supply voltage.

Check the cable between control module terminal #3B and the power window motor #6. Check for a short-circuit to ground. Check for a short-circuit to supply voltage.

Check the cable between control module terminal #16A and the power window motor #4. Check for a short-circuit to ground. Check for an open-circuit. Check for a short-circuit to supply voltage.

Check the cable between control module terminal #19A and the power window motor #1. Check for a short-circuit to ground. Check for an open-circuit. Check for a short-circuit to supply voltage.

Check the cable between control module terminal #7B and the battery. Check for a short-circuit to ground. Check for an open-circuit.

Check the cable between control module terminal #5B and ground: Left or right front seat support. Check for a short-circuit to ground. Check for an open-circuit.

Replace the cable if a fault is found.

• Ignition on
• Try to operate the window lift mechanism to its limit positions (manually and automatically).

Other information: 

• To connect the breakout box, see Connecting the breakout box
• To access the driver/passenger door module (DDM/PDM), see Driver's door module / passenger door module (DDM/PDM), replacing
• To access and replace the power window mechanism, see Window lift mechanism front side door, replacing
• After checking all wiring (and replacing faulty wiring), pass a current across the motor and check that it operates
• See Checking wiring and terminals .

Was a fault detected? 

• YES 

  OKAY:  Troubleshooting has been completed.

• NO 

  Refer to Checking the voltage