Checking components and wiring
If the car is equipped with a 10-pin connector
Check the cable between door control module terminal #10B and power door mirror terminal #4. Check for an open-circuit. Check for a short-circuit to supply voltage.
If the car is equipped with a 16-pin connector
Check the cable between door control module terminal #10B and power door mirror terminal #6. Check for an open-circuit. Check for a short-circuit to supply voltage.
Remedy as necessary.
Try replacing the power door mirror if no fault was found.
Other information:
- When the button is not depressed, the voltage between terminal #10B on the control module connector and ground must be 0 V
- For further information about signals and other values, see Signal specification
- To connect the breakout box, see Connecting the breakout box
- To access and replace the power door mirror, Model years -2003, see Door mirror, replacing . Model years 2004-, see Door mirror, replacing .
- See Checking wiring and terminals .