Adjusting sideways and front-rear

Remove the headlining according to Headlining, replacing

Fig 1: Identifying Screws And Spacers For Gutter Frame

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the 8 screws.

There are two reference holes. One is round and the other is oval.

Lift up the sun roof.

Insert a drift that matches the diameter of the hole

Adjust the sunroof so that it is level at the sides and has even pressure at the front and rear edges.

Test the function of the sun roof by opening and closing it as far as it will go.

Calibrate according to Sun roof module (SRM), calibrating .