Diagnostic trouble code (DTC) information SRS-010C

Condition

NOTE:

If there are other diagnostic trouble codes, that indicate the same component, stored in the Supplemental restraint system module (SRS) then these shall be taken care of first.

The Supplemental restraint system module (SRS) checks the circuit for the seat belt tensioner, right front.

The diagnostic trouble code (DTC) is stored if the control module detects that:

There is interference in the circuit.
Contact with the impact protection's ignition part is interrupted.

The control module's test for the diagnostic trouble code (DTC) starts in the event of:

Ignition position I, II and III. Only during start-up of the supplemental restraint system.

NOTE:

The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.

Fig 1: Identifying Pyrotechnical Seat Belt Tensioner Assembly

Courtesy of VOLVO CARS OF NORTH AMERICA.

Substitute Value

None.

Possible Source

Contact resistance, oxidation or poor contact in connections.
Damaged supplemental restraint system module (SRS).

Fault symptom[s]

SRS warning light on