Checking wiring
- Ignition off, wait for 15 seconds.
- Disconnect the connector from the front right side impact airbag.
- Disconnect the connector for Supplemental restraint system module (SRS).WARNING:
Under no circumstances use an ohmmeter or other live measuring instrument to take readings on a disconnected, non-deployed, pyrotechnical airbag. This could deploy the airbag
Check connectors for damage to pins and connections.
Check the connectors. Check for loose connections. Check for contact resistance. Check for oxidation.
Also check other connectors and connections that connect cables between Supplemental restraint system module (SRS) and the airbag.
Check the cable. Check for loose connections. Check for an open-circuit. Check for a short-circuit to ground. Check for a short-circuit to supply voltage.
Take readings between:
- The Supplemental restraint system module (SRS) #4C/60 (60) and the connector to the side airbag, right front, #1.
- The Supplemental restraint system module (SRS) #3C/59 (59) and the connector to the side airbag, right front, #2.
Remedy as necessary.
Other information
- See Connecting the breakout box
- See Signal specification (1999-2004).
- See Signal specification (2005-2006).
- See Airbag module seat (SIPS), replacing
- See Supplemental restraint system module (SRS), replacing
- See Checking wiring and terminals
- See Cable harness SRS system, repair
- Continue
Refer to Replacing control module