Checking components and wiring
- Switch off the ignition. Wait 10 seconds
- Disconnect the connector from the supplemental restraint system module (SRS)
- Disconnect connector D from the central electronic module (CEM).CAUTION:
Do not touch the terminal pins in the supplemental restraint system module (SRS) and the central electronic module (CEM). There is a risk of static discharge. This could damage the supplemental restraint system module (SRS) and the central electronic module (CEM).
Check the connectors for the supplemental restraint system module (SRS) and the central electronic module (CEM). Check for damage to pins and terminals in the connectors.
Remedy as necessary.
Check the CAN cable between the supplemental restraint system module (SRS) and the central electronic module (CEM). Check for an open-circuit.
Remedy as necessary.
If no fault is found, continue fault-tracing from the central electronic module (CEM).
Other information
- See Connecting the breakout box
- See Signal specification (1999-2004).
- See Signal specification (2005-2006).
- For further information about cable routing and terminals, see the wiring diagram
- See Supplemental restraint system module (SRS), replacing
- To access or replace the central electronic module (CEM) and the connectors, see: Central electronic module (CEM), replacing
- To fault-trace the control area network (CAN), see: Signal missing (CAN)
- See Cable harness SRS system, repair
- See Contents
Continue when the fault has been remedied.
- Continue
Refer to Verification